GENERAL INFORMATION
The following regulatory statement applies to all Radio
Frequency (RF) devices equipped in this vehicle:
This device complies with Part 15 of the FCC Rules and
with Innovation, Science and Economic Development
Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received,
including interference that may cause undesired
operation.
Le présent appareil est conforme aux CNR d`Innova-
tion, Science and Economic Development applicables
aux appareils radio exempts de licence. L'exploitation
est autorisée aux deux conditions suivantes:
1. l'appareil ne doit pas produire de brouillage, et
2. l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est sus-
ceptible d'en compromettre le fonctionnement.
La operación de este equipo está sujeta a las
siguientes dos condiciones:
1. es posible que este equipo o dispositivo no cause
interferencia perjudicial y
2. este equipo o dispositivo debe aceptar cualquier
interferencia, incluyendo la que pueda causar su
operación no deseada.
NOTE:
Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s
authority to operate the equipment.
NORMAL (FIXED SPEED) CRUISE
CONTROL MODE
In addition to Adaptive Cruise Control mode, a Normal
(Fixed Speed) Cruise Control mode is available for cruis-
ing at fixed speeds. The Normal (Fixed Speed) Cruise
Control mode is designed to maintain a set cruising
speed without requiring the driver to operate the accel-
erator. Speed Control can only be operated if the
vehicle speed is above 20 mph (32 km/h).
To change between the different control modes, push
the Adaptive Cruise Control (ACC) on/off button which
turns the ACC on and the Normal (Fixed Speed) Cruise
Control off. Pushing of the Normal (Fixed Speed) Cruise
Control on/off button will result in turning on (changing
to) the Normal (Fixed Speed) Cruise Control mode.
WARNING!
In the Normal (Fixed Speed) Cruise Control mode, the
system will not react to vehicles ahead. In addition,
the proximity warning does not activate and no alarm
will sound even if you are too close to the vehicle
ahead since neither the presence of the vehicle
ahead nor the vehicle-to-vehicle distance is detected.
Be sure to maintain a safe distance between your
vehicle and the vehicle ahead. Always be aware which
mode is selected.
To Set A Desired Speed
Turn the Normal (Fixed Speed) Cruise Control on. When
the vehicle has reached the desired speed, push the
RES (+) or SET (-) button and release. Release the
accelerator and the vehicle will operate at the selected
speed. Once a speed has been set a message “CRUISE
CONTROL SET TO MPH (km/h)” will appear indicating
what speed was set. This light will turn on when the
system is turned on via the on/off control. It turns
green when the cruise control is set.
To Vary The Speed Setting
To Increase Speed
When the Normal (Fixed Speed) Cruise Control is set,
you can increase speed by pushing the RES (+) button.
The driver's preferred units can be selected through the
instrument panel settings. Refer to “Instrument Cluster
Display” in “Getting To Know Your Instrument Panel” for
more information. The speed increment shown is
dependent on the speed of U.S. (mph) or Metric (km/h)
units:
U.S. Speed (mph)
•
Pushing the RES (+) button once will result in a
1 mph increase in set speed. Each subsequent tap
of the button results in an increase of 1 mph.
•
If the button is continually pushed, the set speed
will continue to increase in 5 mph increments until
the button is released. The increase in set speed is
reflected in the instrument cluster display.
Metric Speed (km/h)
•
Pushing the RES (+) button once will result in a
1 km/h increase in set speed. Each subsequent tap
of the button results in an increase of 1 km/h.
•
If the button is continually pushed, the set speed
will continue to increase in 10 km/h increments
until the button is released. The increase in set
speed is reflected in the instrument cluster display.
To Decrease Speed
When the Normal (Fixed Speed) Cruise Control is set,
you can decrease speed by pushing the SET (-) button.
STARTING AND OPERATING
215
5
