Raleigh Audio Premium Extreme RAKK dac, Инструкция по сборке

Страница: 41 / 65

Final Assembly and Wiring
————————————————————————————
Wire the Bottom Panel to the Back Panel
————————————————————————————
Position the back panel on the back of the bottom panel and secure it with three 6-32 screws.
Trim the length of these wires as needed in the following steps.
Wire the AC Power and Ground
1.
Skip this step if you do not have an I2S Adapter.
Dress the loose green wire from the ground buss close to the chassis and connect it to the
“chassis” pad on the I2S Adapter.
2. Skip this step if you do not have a USB Adapter.
If your 8V Regulator has a green wire connected to its “chassis” pad, dress it close to the
chassis and connect it to the ground buss. (This wire should not be present if you have a
three-Input I2S Adapter.)
3. Dress the green wire from the “chassis” pad on the Active Output close to the chassis and
connect it to the ground buss.
4. Dress the green wire from the “DC ” pad on the 12V power supply close to the
chassis and connect it to the ground buss.
5. Dress the white/black power cable that is connected to the 12V power supply as follows:
•
First, from the power supply to the front edge of the panel.
•
Then, along the front edge of the panel to the right edge of the panel.
•
Then, along the right edge of the panel to the back panel.
•
Then, towards the center of the panel to a point under the power connector.
6. Connect the white/black cable to the power connector as follows:
•
Trim the white/black twisted pair at a point even with the ground buss.
•
Trim ½” from the end of the black wire.
•
Strip ¼” from the end of both wires and tin the ends.
•
Connect and solder the white wire to the center pin.
•
Connect and solder the black wire to the bottom pin.
40