Documentation Center
Remove the SD Card from your RAK7244 WisGate Developer D4 Gateway and insert it into your PC. Your PC
should be able to detect it same with the image below:
Figure 19: Creating rak_ap file to your SD Card
Using your "Command Prompt" or "Terminal", navigate to your SD Card and type this command to generate
the "rak_ap" file.
Check if the rak_ap file is created succesffuly. If so, re-insert the SD Card into your RAK7244 WisGate
Developer D4 Gateway and it should work again in Wi-Fi AP Mode.
Configuring the Gateway
Assuming you have successfully logged into your Gateway using SSH, enter the following command in the
command line:
You will now then see a page like the following picture below
cd > rak_ap
sudo
gateway-config
sh
