RAK Mobile Filling Station, Руководство по эксплуатации

Страница: 38 / 70

Copyright 2020, Al-Rakeb Oil, Electricity & Construction Services Company | Kuwait
38
Figure 33. Shows the retention tray.
4. While pumping operation is taking place the inline check valve 4'' is activated to prevent
the fuel from returning back to the fuel conveying truck. Make sure that the cut valve 4'' is
fully opened. This is done by torqueing the handle to the opposite side from its original
position. After this step, the tank will start to fill up. Please refer to figure 34 in order to
have a close look on the position of inline check valve 4'' and the cut valve 4''. Refer to
section 1.3 part 14 to locate the cut valve 4''.
Figure 34. Location of both inline check valve and the cut valve.
5. The Digimon console will show the status of the tank being filled. the operator can navigate
through the Digimon console and check the status of every tank. The tank status can also
be checked using the ProGauge Console located in the control cabin. Please refer to section
1.3 part number 2 and 23 to locate the Digimon console and the ProGauge console.
6. Once the tank is full, the Digimon console and the ProGauge Console will notify the
operator and the overfilling tank alarm console will also alarm the operator with
notification beep. Please refer to section 1.3 part number 8 to locate the overfilling alarm.
7. Once the tank is full, stop the filling truck pump and shut down the shutoff valve. Make
sure to close the cap the beginning of the infeed line.