STEP 5. TEST BEFORE USE
Warnning
* The WiFi timer can only be used for cold water.
* The WiFi timer uses a 433mHz RF connection to communicate with the WiFi Hub, and must be within a 160ft
range, line of sight, of the WiFi Hub.
If there are walls, iron gates or bushes blocking, please shorten the
distance between them to better receive the signal
.
* Soil will absorb WiFi and RF signals,
the best location of the timer is on the faucet 4 to 8 feet (1.2 to 2.4 meters)
above the ground
.
* Do not place the WiFi timer in an underground valve box or anywhere your WiFi and RF signal will be obstructed.
* Under freezing weather, the water timer should be removed from the tap and placed properly indoor to avoid any
danger of freezing.
Note:
When testing, please keep away from the water outlet of the timer to avoid being splashed
and wet.
Congratulations
, you have completed the connection and installation of the WiFi water timer.
Please test whether the internal valve of your water timer is normal before using it.
- 10 -
1.
Keep the faucet turned off.
2.
Press and hold the button of the timer for 3-5 seconds, with a
click
sound, the valve inside
the timer opens for manual watering. After a few seconds, press and hold the button again,
the
click
will sound again, and the valve will close.
3.
Turn on the faucet a little bit, press and hold the button of the timer to check if the water
flow out or shut off as expected. If yes, the valve is normall, please use it with confidence! If
not, please repeat the above steps several times.
The test is over, everything is normal, please keep the faucet fully turned on!
