Rain Bird ESP-LXD, Инструкция по установке, программированию и эксплуатации

Страница: 28 / 138

22 ESP-LXD Controller
Flow Sensors Setup
The Flow Sensor Setup Wizard tells the ESP-LXD controller what flow
sensors are used by your irrigation system.
Flow sensors are not required for the ESP-LXD controller, but they add
functionality by alerting you to abnormally high or low flow rates and
even shutting down affected MVs or stations if flow rates exceed set
thresholds. The ESP-LXD can support up to five flow sensors.
Set Up Rain Bird Flow Sensor
b g
Turn the controller dial to Setup Wizards.
A
The Setup Wizards screen appears. Press the Down Arrow button
to select Flow Sensors; then press Next.
B
The Flow Sensor Setup screen appears. Press the + and – buttons
to enter the desired flow sensor number; then press Next.
1 2
C
Press the + and – buttons to enter the decoder address, pressing
Next and Back to navigate between the number setting fields;
then press Next.
b b
NOTE:
An alarm will show if a duplicate sensor decoder address
is entered for more than one flow sensor. See Section A, Alarm
Conditions for more details.
D
Press the + and – buttons to select the Rain Bird flow sensor model
that you’re using.
3 4
E
Press the + and – buttons to enter the MV you wish to assign to
the flow sensor. Each assigned FloZone will be shown below the
MV field.
5
b e
Repeat this process to set up additional flow sensors. Be sure to
note each flow sensor on your Programming Guide for future
reference.