RAID Xanadu, Руководство пользователя

Страница: 153 / 189

15.2 Removing and Installing Controllers
The procedure for removing a controller from its housing is as follows.
1. Confirm that the power is turned off.
2. Confirm that the power cable of the unit and the cable of the controller in question are not
connected.
3. Take an ejector of the controller in each hand and open them to the left and right.
The ejectors are locked at bottom.
The controller comes out by freeing it on the left and right.
Ejector
4. Holding the ejectors in both hands, pull horizontally approximately 10 cm.
5. Hold the controller firmly in both hands and pull it all the way out.
The procedure for installing a controller in the housing is as follows.
1. Insert the controller in the housing.
Firmly push it all the way in.
2. Close the ejectors and firmly press the protruding portions of the ejectors.
Confirm that both ejectors are locked.
If the controller is not fully inserted, it could lead to malfunction.
-
130
-