MicroRAE User’s Guide
32
1.
Press [MODE] to toggle Roaming “On” or “Off.”
2.
Press [MODE] to scroll to “Exit.”
3.
Press [Y/+] to exit.
9.3.5.5. Radio On/Off
This is only available if your MicroRAE is configured with WiFi or Mesh Radio.
Press [Y/+] to turn the radio on or off, or press [MODE] to advance to the next screen without
changing the the radio’s on/off status.
9.3.5.6. Set PAN ID
This is only available if your MicroRAE is configured with Mesh Radio.
1.
Press [MODE] to advance through the numbers from left to right.
2.
Press [Y/+] to ] to advance through the numbers (1, 2, 3, etc.).
3.
Press [MODE] to register your choice and advance to the next number.
4.
When you are satisfied with the PAN ID, press [MODE] until “?” is selected.
5.
Press [Y/+]. The PAN ID is saved, and you see the confirmation message “Apply
Settings” followed by “Apply Settings”. It automatically advances to “Apply Success”.
After 1 second, it automatically advances to “Set Channel.”
9.3.5.7. Set Channel
This is only available if your MicroRAE is configured with Mesh Radio.
The MicroRAE and any other devices that you want to connect wirelessly must be operating on
the same channel.
Note:
For radio modems operating at 868MHz, only channel 0 is available. For other frequencies,
channels 1 through 10 are allowed.
1.
Press [MODE] to advance through the numbers from left to right.
2.
Press [Y/+] to ] to advance through the numbers (1, 2, 3, etc.).
3.
Press [MODE] to register your choice and advance to the next number.
4.
When you are satisfied with the channel number, press [MODE] until “?” is selected.
5.
Press [Y/+]. The Site ID is saved, and you see the confirmation message “Apply
Settings” followed by “Apply Success”. It automatically advances to “Join Network”.
9.3.5.8. Join Network
This is only available if your MicroRAE is configured with WiFi or Mesh Radio.
You can tell the MicroRAE to automatically join a network. The PAN ID and Channel are shown
for reference (if either is incorrect, you can change it, as described above). Press [Y/+] to join or
[MODE] to advance to “Interval” without making a change.
Note:
If Roaming is turned on,
instead of a PAN ID number, you see “- - -”.
Press [Y/+] to join a network.
The PAN ID and channel are shown. To join, press [Y/+]. To exit to the “Factory Reset,” press
[MODE].
