MicroRAE User’s Guide
30
9.3.2. Sensor On/Off
You can turn sensors on or off via this set of submenus. The word “ON” or “OFF” below each
sensor’s name tells you its status.
1.
Press [MODE] to advance through the sensors.
2.
Press [Y/+] to turn a selected sensor on or off.
3.
Press [MODE] until “?” is selected.
4.
Press [Y/+] to save your selection and exit to “Clear Datalog”. Otherwise, to return to the
first sensor, press [MODE].
9.3.3. Clear Datalog
The instrument displays a floppy disk icon to indicate that a datalog is being recorded. The
instrument stores the measured gas concentration for each sensor, date and time for each
measurement, Site ID, User ID, and other parameters. All data are retained (even after the unit is
turned off) in non-volatile memory so that they can be downloaded at a later time to a PC.
Clearing the datalog erases all data stored in the datalog.
IMPORTANT!
Once the datalog is cleared, the data cannot be recovered.
Note:
The datalog is password protected. You must enter the correct password in order to clear
the datalog.
1.
Enter the password (the default value is 0000).
2.
Press [Y/+].
The message “Log Cleared!” appears briefly on the screen before advancing to “Monitor
Setup.”
9.3.4. Monitor Setup
The Monitor Setup menu provides access to settings for GPS, Site ID, and User ID.
9.3.4.1. GPS On/Off
If your MicroRAE is equipped with GPS, you can turn it on or off:
1.
Press [Y/+] to enter “GPS On/Off”.
2.
Press [Y/+] to turn GPS on or off.
3.
Press [MODE] to save your choice and advance to “Set Site ID”.
9.3.4.2. Set User ID
If your MicroRAE is to be used by a specific user, it can have a uniquely named User ID (a name
or numbers or combination) to help identify it in ProRAE Guardian monitoring software. The
User ID must be eight alphanumeric characters.
1.
Press [MODE] to advance through the characters from left to right.
2.
Press [Y/+] to ] to advance through the letters and numbers (1, 2, 3, A, B, C, etc.).
3.
Press [MODE] to register your choice and advance to the next character.
4.
When you are satisfied with the Site ID, press [MODE] until “?” is selected.
