RADWAG Y/KTP series, Руководство пользователя

Страница: 82 / 176

Procedure:
•
Enter parameter group
< Working modes>
according to ch.
23 of this manual,
•
Choose
„ Counting pieces / Minimum reference mass”
and then set an appropriate value.
Accessible settings:
1 d, 2 d, 5 d, 10 d.
Notice:
While the procedure of evaluation the mass of single piece the the mass
of all pieces put on the pan is lower than the value declared in parameter
„ Minimum reference mass”, the following warning message will
be displayed: < Too low sample mass>.
25.3. Setting a reference unit by entering known piece mass
Procedure:
•
Enter mode
< Counting Pieces>
according to ch. 25.1
of this manual,
•
Press (enter piece mass), then an editing field is displayed
<Reference Unit>
with the screen keyboard,
•
Enter a value and confirm it by pressing , which causes starting
< Counting Pieces>
with automatic setting the reference unit.
Notice:
1. In case of entering a reference unit higher then the maximum weighing
range of the main scale the program will display a message box:
<Value too high>,
2. In case of entering the single piece mass lower than 0.1 d, the
program will display a message box: <Value to small>.
25.4. Setting a reference unit by weighing a sample
Procedure:
•
Enter mode
< Counting Pieces>
according to ch. 25.1
of this manual,
82