RadTech BLIZZARD B84C-L, Руководство пользователя

Страница: 15 / 52

ASSEMBLY
[13]
WARNING: To avoid serious injury or death
: Read and understand SAFETY
INFORMATION on previous pages before installation and operation Perform all assembly with
the assembly properly secured and supported.
T
RACTOR
P
REPARATION
See Dealer for Tractor Preparation information.
S
NOWBLOWER
A
SSEMBLY
The snowblower is assembled at the factory except for the parts in the hardware bag provided with the
snowblower, the chute and the options if appropriate. Use the present manual and lay out all parts for
assembly. Separate bolts and nuts into various sizes. After assembly, torque all the bolts according to
the
Torque Specification Table at the end of the manual.
Installation of the Chute
WARNING:
To avoid serious
personal injury or death: Park the vehicle
on level ground, place the transmission in
neutral, set the parking brake, place all
control levers in neutral, shut off the
engine, remove the ignition key and allow
the rotating parts to stop BEFORE working
on the vehicle.
1. Figure 1: Place the rotation bushing
(item 1) on the snowblower chute base
(item 4).
2. Figure 1: Install the chute (item 2) over the
rotation bushing and install the six 3/8"
spacers (item 3a) and the three 11GA thin
spacers (item 3b) on the chute base
(item 4).
3. Figure 1: Apply grease under the retaining
plates (items 5-6) before installation.
NOTE: Use high quality grease designated
"extreme pressure" and containing
molybdenum disulfide. This grease can
specify "Moly EP" on its label
.
4. Figure 1: Attach the two retaining plates
with 3 holes (items 5) by placing the 2
holes section toward the plate of the
rotation support with six 1/2" x 2" carriage
bolts, six 1/2" lockwashers and six 1/2" hex
nuts (items 6-7-8).
5. Tighten all bolts according to the Torque
Specification Table at the end of the
manual.
Figure 1