RadTech BLIZZARD B84C-L, Руководство пользователя

Страница: 17 / 52

ASSEMBLY
[15]
Snowblower Installation with a Quick Hitch (Category 1 only)
NOTE : For the installation of the snowblower with
a Quick Hitch, two 1 1/2" x 2 1/8" bushings
(668059) (item 10) and one 1 1/4" x 1 7/8"
bushing (668058) (item 11) are required, but they
are not supplied with the snowblower.
1. Figure 3: Make sure the parking stand is
lowered. To do this, remove the round wire lock
pin (item 9) from the parking stand (item 8),
lower the parking stand and insert the round
wire lock pin (item 9) under the snowblower
attachment tube
.
2. Figure 3: Insert a 1 1/2" x 2 1/8" bushing
(item 10) between the plates of the snowblower
lower hitch and secure in the upper hole
(item 4) with the pin (item 1) and the 7/16"
linchpin (item 3). Do the same on the other
side.
3. Figure 3: Insert a 1 1/4" x 1 7/8" bushing
(item 11) between the plates of the snowblower
upper hitch (item 7) and secure with the pin
and the linchpin (item 6) provided with the
tractor.
4. Figure 3: Make sure that the quick release
latches (item 2) are securely closed. Lower the
3-Point so that the hooks on the quick hitch
(item 2) are lower than the snowblower pins
and
bushings (items 1 and 10). Reverse the
tractor slowly until the hooks are under
snowblower pins and bushings (items 1 and
10). Then, raise the 3-Point until the quick-
release latches (item 2) snap on the pins with
the snowblower bushings (items 1 and 10) to
lock the system
.
5. Figure 3: Adjust the snowblower using the
upper arm of the tractor (item 5) so that the
snowblower is perpendicular to the ground .
6. Figure 3: Raise the parking stand. To do this,
remove the round wire lock pin (item 9) from
the parking stand (item 8)
, raise the parking
stand and insert the round wire lock pin
(item 9) over the snowblower attachment tube
.
7. Go to " Preparation of the Driveline " section
for further installation of the blower .
Before connecting snowblower driveline
to tractor drive shaft, make sure driveline
is not too long in raised, lowered and
middle position. If the driveline is too
long it must be shortened, to avoid
damaged to tractor. See pages 17 and 18
for instructions.
CAUTION
Figure 3