Setting Up and Programming the Digital Receiver
Page 26
Version 1.0
7.6.4
Conducting a Manual Search
Once the settings of Sections 7.6.1 through 7.6.3, above, have been concluded, you may initiate a
manual search.
•
Use the
p
and
q
keys to highlight the “Start Search“ field.
•
Press the MENU-key to start the search.
While the search is in progress, a clock will appear at the lower right-hand corner of
the screen. You will also see a blue bar indicating the extent of the frequency band
that has thus far been searched. The other items appearing onscreen have the
following meanings:
DF: .... -
The satellite downlink frequency involved
SR:.... -
The symbol rate
New:... -
The total number of new channels saved to the receiver’s memory
Once the search has been successfully concluded, the message “Search OK“ will
appear onscreen.
•
Press the EXIT-key to exit the menu and view the
channel found.
If the search fails to locate a channel, one of the following error messages will
appear onscreen:
“Tuning fail“
-
Check the symbol rate.
“Search fail“
-
Check the local-oscillator frequency, the signal
strength, the 22-kHz setting, and the choice of satellite
to be involved.
“No free channel“
-
Check the downlink frequency.
“Search cancel“
-
The search was cancelled by pressing the EXIT-key
before the search could be concluded.
EXIT
Setup Value
Down Frequency
Manual Search
1 - 3 - 6 - 4
Symbol Rate
DF:4000 SR:28.125 New:18
LNB Polarity
Start Search
Search OK
