Programming and Operating the Analog-Receiver Section
Version 1.0
Page 13
6.2
Preselecting Channels from the Main Menu (Display Page 1)
•
Press the MENU-key on the remote control while the
receiver is switched on.
The following menu will then be displayed onscreen:
•
Either use the
t
and
u
keys to select a channel/broadcaster,
or
•
enter a 3-digit channel number.
•
If necessary, reset the local-oscillator frequency
(5.15 GHz/9.75 GHz or 10.00 GHz/10.60 GHz).
If your antenna is capable of receiving C-band broadcasts, you may reconfigure the
receiver setup in order to allow receiving them by using a setting of C-05.15 GHz.
•
Use the
t
and
u
keys or the numerical keys to adjust/reset
the channel frequency to the desired value (cf. the addendum
for a list of available channel frequencies).
•
Select either horizontal or vertical polarization.
•
Switch the 22-kHz control frequency ON or OFF.
•
Select the desired decoder status (NONE/MAC/PAL1/PAL2).
•
Select the desired picture contrast.
•
Switch the child-protection feature ON in order that the channel
selection can only be altered by a numerical entry, and can no
longer be altered using the
p
and
q
keys.
While the cursor ( > ) is in the bottom display line, you may use the
q
key to switch
to the next menu. While it is in the top display line, pressing the
p
key will return
you to the preceding menu.
GB
CHANNEL
:
400
BAND
:
KU-09.75GHZ
FREQ.
:
12150.00MHZ
POLARITY
:
HORZ.
22KHZ
:
OFF
DECODER
:
NO
CONTRAST
:
5
P. LOCK
:
OFF
>
MAIN MENU
