Programming and Operating the Analog-Receiver Section
Page 12
Version 1.0
6
Programming and Operating the Analog-Receiver Section
•
Switch the receiver on by pressing the ON/OFF-key.
•
Press the A/D-key on the remote control in order to switch
from using the receiver’s digital section to using its analog
section.
NOTE:
You may suppress the picture for the current channel and obtain a blue screen by
pressing the BACK-key, if desired. The system menu will be displayed onscreen
even in the absence of an input signal.
•
You may also suppress the sound track for the current channel
by pressing the MUTE-key, if desired, in which case the message
“SOUND OFF“ will appear onscreen. Pressing the MUTE-key a
second time will restore the sound track.
6.1
Setting the Basic Parameters from the System Menu
•
Simultaneously press the
p
and
q
keys on the receiver’s
front panel while the receiver is in standby mode and hold
them depressed for 3 seconds.
The following menu will then be displayed onscreen:
•
Use the
p
and
q
keys to shift the cursor to the desired position
(the highlighted display line).
•
Use the
t
and
u
keys to select the desired setting.
•
Select the desired language (Deutsch, English, Français, Italiano).
•
Select an LNB-local-oscillator frequency of 9.75 GHz/10.00 GHz.
•
Adjust the local-oscillator frequency in steps of 0.25 MHz until it
agrees with your LNB (the available frequency-adjustment range
is
±
15.00 MHz).
•
Select “ON” if you intend to use the receiver’s SMATV-feature
(DiSEqC Version 1.0)
•
Press the STORE-key.
The data have now been saved and the receiver will automatically switch off.
LANGUAGE
:
ENGLISH
DRO SHIFT
:
00.00MHZ
LNB FREQ.
:
9.75GHZ
SMATV
:
OFF
SYSTEM MENU
