Radix DSR 9000 TWIN, Руководство пользователя

Страница: 45 / 56

DSR 9000 Twin 2005.02.04 (GB) - 17
GB
NOTE :
From the Antenna Positioner screen, select "Select Satellite" and then use the buttons to select
the satellite.
Select "Select Transponder" and select the TP with the strongest signal.
Select "Nudge East/West" and then use the buttons to move the antenna.Find the position where
the Signal Strength is strongest.
When doing this, if the position of the antenna is well away from the target satellite, use "Move
East/West" in "Set-up Limit" to move the antenna first.
Alternatively, select "Nudge East/West" and then use the buttons to move the antenna.
Each time you press either button, the antenna will automatically find the satellite.
Once the satellite is located, select "
Store Satellite
" and then press the
OK
button. The position of
the satellite is stored.
Press the
MENU
button on the remote control to go to the
Main Menu.
Select "
Antenna Positioner
" and then press the
OK
button.
Select "Set-up Limit" and then press the
OK
button.
Select "Move East/West". Use the button to move the
antenna to the East Limit position.
Select "Set East Limit" and then press the
OK
button to save
the East Limit set in Step 4.
Select "Move East/West" again. Use the button to move the
antenna to the West Limit position.
Select "Set West Limit" and then press the
OK
button to save
the West Limit set in Step 6.
7.2.2.1 DiSEqC 1.2
DiSEqC 1.2
17
To position the antenna using the DiSEqC 1.2 method, you
will need to set the movement limits first. The reason for this is
to reduce the danger of the antenna coming into contact with
any obstructing object during the antenna positioning
operation. When the movement limits are set, the antenna
only moves within the limits specified.
If you select the stored satellite, the antenna moves in the direction of the satellite's position.
NOTE :
To disable the movement limits, select "Disable Limits" and then press the
OK
button.
To position the antenna at the center, select "Go to Reference" and then press the
OK
button.
Once the limits are set, locate the reference satellite.
NOTE :
After locating a satellite, perform Recalculation. This enables you to locate another satellite
automatically by using the currently selected satellite as a reference point. However, this only provides
an approximate position, so you will need to fine-tune the search.
Select "Recalculate Position" and then press the
OK
button.
When the message asking you to confirm your selection appears, press the
OK
button.
Satellite Positions are stored in the Antenna Positioner. Therefore, you will need to manually set
the position of satellites that the Antenna Positioner does not currently support.