RadiSys EPC-5A, Справочное руководство по аппаратному и программному обеспечению

Страница: 103 / 156

Chapter 9: Troubleshooting & Error Messages
Page 97
9 9
ERROR INITIALIZING HARD DISK 0
Problem: The IDE disk controller for drive C cannot be initialized.
Solution(s): If you are using an EXP-MX mass storage module, ensure that the
module is fully seated in the subplane and that the +5V and +12V
LEDs indicate that the module has power.
If you are using the EXM-9 to cable to an external disk, make sure
that you have power to the disk, the ribbon cable is good and correctly
oriented, and that the end of the ribbon cable is not shorting to the
front panel of the EXM-9.
If you are not using an IDE drive, enter the BIOS setup program.
Press F3 to enter the Fixed Disk Menu. Change the drive type to
match the device being used.
EXM CONFIGURATION ERROR
Problem: The EXMs installed (or not installed) do not match the configuration
information in the CMOS Setup.
Solution(s): Run the BIOS setup program. Enter the EXM menu. Verify the
information listed on the screen, save any changes and reboot.
If necessary, refer to the section EXM Setup Screen and/or your EXM
manual(s) for more details.
FLOPPY DISK CNTRLR ERROR OR NO CNTRLR PRESENT
Problem: The configuration information in the BIOS setup says that one or more
floppy disk drives are expected, but a floppy disk controller could not
be found.
Solution(s): If you have no floppy diskette drives, enter the setup program and set
both floppy drives to “NONE.”
If you are using an EXP-MX module, verify that the EPC-5A,
subplane, and EXP-MX are properly seated, and check the LEDs on
the front panel of the EXP-MX to ensure that both the +5V and +12V
supplies are available.