RadioMaster MT12, Инструкция по эксплуатации

Страница: 45 / 49

Units - Units of measure. Options are metric or imperial .
Play delay (sw. mid pos) - The minimum time in milliseconds a switch must be in the middle position before a
special function will get activated. This is used to prevent the middle position from being activated on a
three-position switch when switching from low position to high position.
USB Mode - Sets the default action when a USB cable is plugged into the USB data port and the radio is
powered on. Options are: Ask , Joystick , Storage , and Serial .
Def Chan Ord - The default channel order for new models and the trainer screen. The letters stand for: A =
Aileron, E = Elevator, T = Throttle, R = Rudder. Changing this setting does not affect existing models.
RotEnc Mode (Rotary Encoder Mode) - Set to Normal by default. The Inverted option reverses the direction
of the roller.
Mode - The stick mode that will be used for the transmitter. Defined by what actions the left stick takes. The
options are:
•
1: Left = yaw+pit (pitch)
•
2: Left = yaw+thr (throttle)
•
3: Left = rol (roll)+pit (pitch)
•
4: Left = rol (roll)+thr (throttle)
10.3. Global Functions
Global functions are special functions that apply to all models on the Radio. They are configured exactly as
model Special Functions and the same functions are available. For more information about configuring
Global Functions, refer to the
Special Functions section as they are essentially the same.
10.4. Trainer
The Trainer screen in Radio Settings is used to configure how the radio in Master mode will handle the
signals from the radio in Slave mode. It contains the below configuration options.
Trainer Ccreen in Radio Settings
For each of the four main control inputs (Ail, Ele, Thr, Rud), the following options can be configured (for each
row, from left to right).
Mode - How the radio in Master mode will handle the signals from the radio in Slave mode.
•
OFF - Stick values from the radio in Master mode will be used - no input from the radio in Slave mode.
•
+= Adds the stick values from both the radios in Master and Slave modes.
•
:= Replaces the stick values from the radio in Master mode with the stick values from the radio in Slave
mode. (Default)
•
Weight - Percentage of stick travel to use of the radio in Slave mode. Use negative values to change the stick
direction.
•
Source channel - The channel from the radio in Slave mode that is mapped the control input.
Multiplier - This value changes the weight of all the sticks together.
Cal (calibrate) - Sets the center stick value of the radio in Slave mode.
The trim from the radio in Master mode is usually used. Set the trims on the radio in Slave mode to their
center.
The radio in Master mode is the one that gets bound to the model receiver.