•
Weight
- Percentage of the source value to use. Long-pressing here will switch from numerical value to a
global variable.
•
Offset
- The value added to or subtracted from the source.
•
Trim
- Specifies whether or not to include the trim values in this mix. For the trim values to be included, the
trim field for the relevant input must also be enabled on
INPUTS
screen.
•
Curve
- Specifies the type of curve that will be used. See the
curve
section on the
explanations of the different curve types.
•
Switch
- The physical switch that activates this mix line (optional). If no switch is selected, then the mix will
be active by default.
•
Warning
-when selected, the radio will beep when this mix is active. You can choose from OFF or beep
patterns 1, 2, 3.
•
Multiplex
- The multiplex setting defines how the current mixer line interacts with the others on the same
channel.
Add
will add its output to them,
Multiply
will multiply the result of the lines above it, and
Replace
will replace anything that was done before it with its output.
•
Modes
- Specifies which flight modes this mix is active for. Visible modes are active.
•
Delay up
- Creates a time delay in seconds between when the source value increases and when it is output.
•
Delay down
- Creates a time delay in seconds between when the source value decreases and when it is
output.
•
Slow up
- Adjusts the transition speed for source value increases. Specify the time to transition from -100%
to + 100% in seconds. You can specify a range from 0.0 seconds to 25.0 seconds.
•
Slow down
- Adjusts the transition speed for source value decreases. Specify the time to transition from -
100% to + 100% in seconds. You can specify a range from 0.0 seconds to 25.0 seconds.
3.8.
Outputs
The
Outputs
screen is where final adjustments to the control data are made (including subtrims, curves,
endpoint, and center values) before finally sending the control data to the RF module. This is where the
channel center, limits (to prevent servo binding) and output direction are set.
A
Trim
is a temporary adjustment to a flight control normally done while in operation with a trim switch. A
Subtrim
is a semi-permanant adjustment to a flight control that is normally configured when setting up the
model in the output settings.
Outputs screen
The output screen shows all the output channels. For each output line, it displays the values for the subtrim,
minimum and maximum limits, direction, curve, and subtrim mode. After the last output line is the option
Trims=>Subtrims
. When this option is selected, it adds the current trim value to the subtrim value for each
configured output. The trim value is then reset to zero.
Selecting an output line will give you the following options:
•
Edit
- Opens the output configuration screen.
•
Reset
- Sets the subtrim value back to zero. The trim value is not changed.
•
Cpy Trims -> Subtrim
- Adds the current trim value to the subtrim value. The trim value is not changed.
•
Cpy Sticks -> Subtrim
- Adds the current value of the stick deflection as the subtrim value.
•
Cpy min/max to all -
Copies the settings in Min / Max field of selected channel to all other channels.
Содержание MT12
Страница 5: ...1 3 Radio overview...
