Page
7
of
29
©
2019 Radiocrafts AS
RC1180-MPC1/RC1701HP-MPC1 User Manual (rev. 1.1)
RC1180-MPC1
USER MANUAL RC1701HP-MPC1
6 Set up and use the Tamper pin
The Tamper pin can be enabled by setting configuration parameter MPC_IO, and the polarity of the tamper
function is set by configuration parameter MPC_POLARITY. You can also enable an internal pullup for the Tamper
pin in the same way as it can be done for other inputs. This is enabled by configuration parameter MPC_PULLUP.
When the Tamper pin is enabled as mentioned above, and the Tamper pin is activated the MPC module will set the
alarm bit in the STATUS byte of the next message. The STATUS byte is found in the transport layer header.
