Radiocrafts MPC1 Series, Руководство пользователя

Страница: 13 / 30

Page 12 of 29
©
2019 Radiocrafts AS RC1180-MPC1/RC1701HP-MPC1 User Manual (rev. 1.1)
RC1180-MPC1
USER MANUAL RC1701HP-MPC1
Command
Details Comments ASCII hex
‘@RC
’
0x40
0x52
0x43 Reset Configuration Memory to factory defaults
This command will reset the configuration memory to the factory
defaults.
Argument Options Returns
(none) (none) Prompt (>)
At the same time as you run this command you must also assert
the config pin on the module. This is an extra safety to avoid
unintended resets to factory default. It can be disabled by setting
CONFIG_INTERFACE = 1 in the configuration memory.
Note! This command will
also overwrite the serial
number of the module
@’RR
’
0x40
0x52
0x52 Reset
This command will reset the module. It has the same effect as
pulling the reset pin low.
Argument Options Returns
(none) (none) Prompt (>)
At the same time as you run this command you must also assert
the config pin on the module. This is an extra safety to avoid
unintended resets to factory default. It can be disabled by setting
CONFIG_INTERFACE = 1 in the configuration memory.
‘0’
0x30 Test Mode 0
– List configuration Memory
This command will list all the contents of the non-volatile
configuration memory.
Argument Options Returns
(none) (none) Configuration
memory
+Prompt (>)
‘1’
0x31 Test mode 1
– TX Carrier
Argument Options Returns
(none) (none) (none)?
Prompt?
Note! Before using test
mode 1 you need to send
a normal package so that
the TX frequency is
calibrated.
Note!! It is important to
enter Test mode 3 before
exiting the configuration
mode (‘X’) in order to
ensure proper operation
in normal mode.
Note!!! Test mode 4 must
be used between Test
modes 1 and 2.
‘2’
0x32 TX modulated signal, PN9 sequence
Argument Options Returns
(none) (none) (none)?
Prompt?