Version 1.0 - August 2022
14
User manual SDM Battery Series
Lithium-ion battery chargers are to be used exclusively for charging 18V Lithium-ion battery packs with the
maximum capacity of 5.6.
6.
Battery
Before initial use, check that the voltage and frequency stated on the charger’s rating plate
match the figures for your own electrical supply.
Unplug charger immediately if the cable or charger is damaged. Unplug immediately
if any sign of smoke or flames.
To reduce risk of injury, charge only rechargeable Radial batteries, other types of batteries
may burst causing personal injury and damage.
Do not submit the casing to impact or drill into the casing. Do not throw battery packs or
charger in fire or immerse in water. Keep battery packs dry.
Do not use any damaged or deformed battery packs.
Radial chargers should only be operated between 0-49 degrees Celsius. Keep away from
moisture.
Slightly acidic, flammable fluid may leak from defective Li-ion battery packs. If battery fluid
leaks out and comes into contact with your skin, rinse immediately with plenty of water. If
battery fluid leaks and comes into contact with your eyes, wash them with clean water and
seek medical treatment immediately.
6.1. Battery pack faults
Warning indicator stays on
The battery pack is not being charged. The temperature is too high or too low. If the temperature of the
battery pack is between 0 - 49 degrees Celsius, the charging process begins automatically.
Warning indicator flashes on
The battery pack is defective, remove from charger immediately.
The battery fails to charge, contacts may be dirty. Remove the battery pack, clean the contacts and
replace the charger.
Warning beep
In the case of overheating, the battery will give a loud beep tone. The Lithium-ion battery should be
disconnected immediately to cool down. The Lithium-ion battery can be used again once it is cooled down.
Note:
In the case of prolongued activity of electromagnetic disturbances, the battery charger
ends the charging process prematurely for safety reasons. Remove the plug and plug in
again after 2 seconds.
Note:
To prevent the battery from draining, always remove battery from tool before storage.
!
!
!
