Version 1.0 - August 2022
8
User manual SDM Battery Series
5.5. Password screen
The password screen shows whether the tool is locked or unlocked. If the tool is locked the parameters of
the SDM Battery Series cannot be edited.
Password can be entered by pressing the “
ENTER
“ key and using the “
UP
” or “
DOWN
” key.
!
!
To enter the Tool ID,
use password “
1234
” and then press "
LEFT
"
To set torque and / or angle and to enable/disable RF,
use
password “
FFFF
” and then press "
RIGHT
"
5.6. Tool ID and softeware information
The
PRIMARY SECTION -
shows
the Tool Location ID.
The
SECONDARY LEFT
- shows the Motor Controller Firmware version.
The
SECONDARY RIGHT
- shows the screen Firmware version.
Press "
DOWN
" to display the tool time in HH:MM:SS format.
Press "
DOWN
" again to display a screen for internal use only to view log location.
Press "
DOWN
" again to display a second internal use only log screen.
Press "
DOWN
" again to return to the Tool ID screen.
Press "
RIGHT
" to exit back to the Main screen.
