Version 1.0 - August 2022
18
User manual SDM Battery Series
13.
Tool Fault codes
F-01
Tool Disabled (by external control)
F-02
Rapid Trigger pull – trigger was pulled before configuration delay was complete
1-FF
USB enumeration fault
A-10
Motor controller communication timeout
A-55
A display software version update was detected
B-01
Failure to update Motor Controller Software
B-85
RF ACK Timeout (we did not get a serial ACK messages from the transceiver)
B-E1
RF Transmit NAK–“Channel Access Failure”
B-E5
RF Transmit NAK–“Frame Too Long”
B-E9
RF Transmit NAK–“No ACK Received”
C-01
Configuration ID value is 0 or greater than 8
C-02
Number of configuration steps is greater than 8
C-03
Current Step ID is greater than the current number of steps
C-04
Total Gang is greater than 8
C-05
Current Gang count is greater than Total Gang
C-06
Current Torque High Limit is greater than the Tool’s maximum Torque value (Tool’s max
torque value is configured in the Factory Set Points) OR Current Torque High Limit is less
than 0
C-07
Current Torque Low Limit is greater than the Tool’s maximum Torque value OR Current
Torque Low Limit is less than
C-08
Current Torque High Limit is less than Current Torque Low Limit
C-09
Current Torque Low Limit is greater than Current Torque High Limit (Fault code to be
removed)
C-0A
Current Angle High Limit is greater than the Tool’s maximum Angle value (to be set to
9999)
C-0C
Current Angle High Limit is less than Current Angle Low Limit
C-0D
Current Angle Low Limit is greater than Current Angle High Limit (Fault code to be
removed)
C-0E
Tool configuration step is a Target torque and the target value is outside the torque high
and low limits
C-0F
Tool configuration step is an Target Angle and the target value is outside the angle high
and low limits
C-10
Tool configuration step is not set for either Angle or Torque
C-11
Current Threshold value is greater than the maximum tool torque OR Current Threshold
value is less than 0
C-12
Current Free Speed is greater than maximum motor speed
C-13
Current Shiftdown Speed is greater than maximum motor speed
