32
EN
16.1 Automatic twilight function; configuration of sensitivity
i
The automatic twilight function is switched on by setting
or changing the sensitivity.
Configure the brightness at the level (twilight) which the
blinds should be closed.
If you intend not to use the automatic twilight function,
it is necessary to unplug the light sensor from the
RolloTron Standard device or deactivate the automatic
twilight function.
Set the current brightness (twilight) as set
limit and switch on the automatic twilight
function.
1.
+
Simultaneously press the buttons.
The current brightness is now set as the set
limit and the automatic twilight function
is activated. If this value is exceeded, the
roller shutters will roll down to the lower
endpoint.
2.
Pay attention to the twilight LED.
OFF
Automatic twilight function OFF
ON
Automatic twilight function ON
Slowly flashing...
◆
if the set limit is exceeded.
◆
if the current brightness value is
within the measured range while
configuring the set limit.
Rapid flashing
If the current brightness value is outside
the measuring range, the set limit is set
to the measured range limit.
3.
You can switch the automatic twilight
function on and off as required.
In order to do so, press and hold the
twilight button for approx. 1 second.
