30
EN
15.1 Automated solar function; configuring sensitivity
i
2.
Pay attention to the solar LED.
The automated solar function is switched on by setting
or changing the sensitivity.
Configure the brightness at the level which the blinds
should be closed.
If you do not intend to use the automated solar function,
it is necessary to remove the solar sensor from the window
pane and protect it from the sunlight or remove the con-
nector from the RolloTron Standard device.
Set the current brightness as set limit and
switch on the automated solar function.
1.
+
Simultaneously press the buttons.
The current brightness is now set as the
set limit and the automated solar function
is activated. If this value is exceeded, the
roller shutters will roll down to the light
sensor.
OFF
Automated solar function OFF
ON
Automated solar function ON
Slowly flashing...
◆
if the set limit is exceeded.
◆
if the current brightness value is
within the measured range while
configuring the set limit.
Rapid flashing
If the current brightness value is outside
the measuring range, the set limit is set
to the measured range limit.
3.
You can switch the automated solar
function on and off as required.
In order to do so, press and hold the sun
button for approx. 1 second.
