RACOM MG102i, Руководство по эксплуатации

Страница: 50 / 175

Important
If configuring the Protocol server together with VPN tunnels the "Poll response control"
protocol specific parameter must be turned off.
Common parameters
For any SCADA protocol, the Transport protocol and the specific port can be chosen. The default values
is UDP port 8882. The unit listens on this port for incoming messages and forwards them to the Protocol
server itself.
Note
Only UDP protocol is currently implemented.
The parameters described in this section are typical of most protocols.
There is only a link to them in description of the respective Protocol.
Mode of Connected device
List box: Master, Slave
Default = Master
The typical SCADA application follows the Master–Slave scheme where the structure of the message
is different for the Master and Slave SCADA units. Because of that, it is necessary to set which type
of SCADA unit is connected to the Unit.
Important
For the SCADA Master, set Master, for the SCADA Slave, set Slave.
MG102iGPRS/UMTS/HSPA+/LTE router – © RACOM s.r.o. 50
Web Configuration