RACOM MG102i, Руководство по эксплуатации

Страница: 40 / 175

Prior to setting up an
access point
, it is always a good idea to run a network scan for getting a list
of neighboring WLAN networks and then choose the less interfering channel. Please keep in mind that
two adequate channels are required for getting good throughputs with 802.11n in the 40 MHz radio
band.
Running in
client
mode, you can select the network to which you want to connect to and enter the
required authentication settings. You may also perform a WLAN network scan and pick the settings
from the discovered information directly. The credentials can be obtained by the operator of your WLAN
access point
.
Running in
managed
mode, the access-point can be controlled over CAPWAP (RFC 5415). It establishes
a layer-2 tunneling protocol to encrypt transmission of user data from connected stations. You can
configure the following settings:
Primary Access Controller Specifies the primary access controller.
Secondary Access Controller Specifies the secondary access controller.
MG102iGPRS/UMTS/HSPA+/LTE router – © RACOM s.r.o. 40
Web Configuration