rackit Paradigm, Инструкция по установке и эксплуатации

Страница: 37 / 48

2. Locate your first computer interface cable. It will have a 25-pin “D”
connector at one end. Plug this cable into any lettered channel port on
the rear of the master Paradigm. The other end of the computer
interface cable will have five connectors: a 15-pin “HDD” connector
for your video, a 5-pin DIN/6-pin miniDIN connector for an AT or PS/
2 keyboard connection, and a 9-pin serial/6-pin miniDIN connector
for a serial or PS/2 mouse connection. The PS/2 mouse connector is
designated by a yellow band or mouse icon.
Use only the keyboard and mouse connectors that are appropriate for Use only the keyboard and mouse connectors that are appropriate for
Use only the keyboard and mouse connectors that are appropriate for Use only the keyboard and mouse connectors that are appropriate for Use only the keyboard and mouse connectors that are appropriate for
your PC, and leave the others unconnected.
your PC, and leave the others unconnected. your PC, and leave the others unconnected. your PC, and leave the others unconnected. your PC, and leave the others unconnected.
Plug these connectors into the appropriate ports on your computer.
3. Locate your next computer interface cable. Repeat step 2 with all the
computers that will be attached to your master Paradigm. Next, attach
the remaining computers to the slave Paradigm.
Connecting Computers to the Paradigm
1. Power down the computers that will be part of your Paradigm system.
Make sure that both of your Paradigm units are turned off.
31
Appendices
PO
WER
M
SE
KB D
10
0-2
40 V
M AD
E IN
U SA
VID
EO
SE RIA
L
G
H
E
F
C
D
A
B
PA TE
NT P
EN DIN
G
T 2
A, 2
50 V
AC
MOUSE PORT
KEYBOARD PORT
VIDEO PORT