rackit Paradigm, Инструкция по установке и эксплуатации

Страница: 16 / 48

Paradigm Installer/User Guide
10
Convention Key Sequence or Value
Enter Command Mode:
<CM> 1. Press and hold down the ‘Num Lock’ key.
2. Press and release the minus (-) key on the numeric keypad.
3. Release the ‘Num Lock’ key.
Note: For alternate hot-key sequences, see ‘System Control &
Maintenance’ later in this chapter.
<Enter> Press the ‘Enter’ or ‘Return’ key. The <Enter> command is used to
execute an instruction and exit from Command Mode.
Addr The letters over the push-buttons on your Paradigm are your PCs'
addresses. Enter the letter, A-H, for the PC you're selecting. For
cascaded systems, enter the address of the base unit first.
Example: You have a Paradigm unit cascaded from channel B of
your base unit. To access the PC at channel C of this second
(cascaded) unit, enter
BC.
<ESC> Press the ‘Escape’ key. The <ESC> command is used to exit
Command Mode without executing an instruction.
The following conventions appear throughout this chapter to illustrate
commands for operating the Paradigm. Whenever you see one of the
symbols listed on the left side of the table, substitute the corresponding
steps or values listed on the right side of the table.
Keyboard Control