rackit Paradigm, Инструкция по установке и эксплуатации

Страница: 13 / 48

7
Installation
6. Locate the power cord that came with your Paradigm unit. Plug it into
the IEC power connector on the Paradigm. Make sure that the power
switch is off, then plug the other end of the power cord into an
appropriate AC wall outlet. This outlet must be near the equipment
and easily accessible to allow for unplugging prior to any servicing of
the unit.
7. Power-up your Paradigm unit first, then all attached computers.
The Paradigm and all attached computers should be
powered-down before servicing the unit. Always disconnect
the power cord from the wall outlet.
100-240V ,
.1A,
50/60 Hz
1
0
!