rackit Paradigm, Инструкция по установке и эксплуатации

Страница: 34 / 48

Paradigm Installer/User Guide
B: Pairing
Pairing connects two Paradigm units serially, allowing access to 16
computers with one keyboard, monitor and mouse without using a
computer port. It is used in place of cascading two units. To pair your
Paradigm units, use the instructions below instead of those given in the
Installation chapter.
Initial Configurations
1. Select one of your two Paradigm units to be used as the slave unit.
2. Connect your VGA monitor cable to the port labeled on the back of
this unit. Next, connect your keyboard to the port labeled on the
same unit.
3. Locate the power cord that came with your Paradigm unit. Plug it into
the IEC power connector on the Paradigm. Make sure that the Paradigm
power switch is off, then plug the other end of the power cord into an
appropriate AC wall outlet. This outlet must be near the equipment
and easily accessible to allow for unplugging prior to any servicing of
the unit.
28
100-240V ,
.1A
, 50/60 Hz
1
0
!
SETUP
A
E
USER