rackit Paradigm, Инструкция по установке и эксплуатации

Страница: 38 / 48

Paradigm Installer/User Guide
4. Locate the power cords that came with your Paradigm units. Plug each
one into the IEC power connectors on the Paradigm units. Make sure
that the power switches are off, then plug the other end of the power
cords into appropriate AC wall outlets. This outlet must be near the
equipment and easily accessible to allow for unplugging prior to any
servicing of the unit.
5. Power-up your slave Paradigm first followed by your master Paradigm,
then all attached computers.
The Paradigm and all attached computers should be powered down before The Paradigm and all attached computers should be powered down before
The Paradigm and all attached computers should be powered down before The Paradigm and all attached computers should be powered down before The Paradigm and all attached computers should be powered down before
servicing the unit. Always disconnect the power cord from the wall outlet.
servicing the unit. Always disconnect the power cord from the wall outlet. servicing the unit. Always disconnect the power cord from the wall outlet. servicing the unit. Always disconnect the power cord from the wall outlet. servicing the unit. Always disconnect the power cord from the wall outlet.
Adding New Channels with Paired Units
1. Select ‘Add Channel’ from the Channel Maintenance Menu. Type in a
new channel name, up to 14 characters long, and press Enter
Enter
Enter Enter Enter.
2. At the next prompt, type in the letter “A” if the PC is attached to the
master unit or “B” if it is attached to the slave unit. Press Enter Enter Enter Enter Enter.
3. When prompted for another cascade level, type Y and press Enter Enter Enter Enter Enter.
4. Type the letter that corresponds to the computer port that the computer
is attached to on the Paradigm and press E
EE
EEnter
nter
nter nter nter.
5. Type
N
when prompted for another cascade level and press E
EE
EEnter
nter
nter nter nter.
Press Esc
Esc
Esc Esc Esc at any point to exit this operation without adding a channel.
Note: Keyboard switching is not available on paired units. All other
keyboard controls function as described earlier in the manual.
32
100-240V ,
.1A,
50/60 Hz
1
0
!