• Once the scene has loaded, remove the card and insert the SD card provided with the switch*.
Note: If the switch was not supplied with an SD card, remove the card used for recording, upload the file to it from a
computer and insert it back in to VBOX Video HD2.
• Within a few seconds, the HD2 will beep and the OK light will slowly flash
orange
.
• Power cycle the unit.
• Remove the SD card provided with the switch and reinsert the SD card used for recording.
*Bluetooth logging buttons purchased before the release of Firmware version 1.2.45 (prior to October '16) would not
have been supplied with an SD card and will require a pairing file, obtainable from Racelogic, when upgrading to
Firmware version 1.2.45 or later. To do this, please remove the rear cover of the Bluetooth switch, on the inside of the
rear cover you should then see a 12 digit code written on a silver sticker (MAC Code), as seen below:
https://en.racelogic.support//Product_Info/Video_Data_Loggers/VBOX_Video_HD2/VBOX_Video_HD2_User_Guide/04_-
_HD2_Logging
34
