Rabbit EM1500, Руководство по эксплуатации продукта

Страница: 20 / 120

16
www.rabbit.com
Getting Started
In the status/debug area of the program window, there is a grouping of controls for the auxiliary I/O that
looks like this:
Figure 2.3 AUX Tray
Detailed information about the status/debug area of the configuration program is in Section 5.1.11 .
2.3.2 Wiring the Demo Board to the Selected EM1500
You must follow these steps before you can use the Demo Board to test the relay and digital I/O:
1. Use a single wire to cK from the Demo Board to V
input
(screw terminal) on the EM1500.
2. Use a single wire to connect GND from the Demo Board to GND (screw terminal) on the EM1500.
3. Connect the 9-wire assembly with plug that came with the Tool Kit to the 9-pin connector on the
EM1500. The3 pins for the relay, plus the 2 digital outputs and 3 digital inputs are all available here.
2.3.3 Digital Output
To test the digital output, wire OUT0 and OUT1 to any LED on the Demo Board. To locate the wires com-
ing from OUT0 and OUT1, do one of 2 things: look at the unit itself, then read the text on the back panel
labelling the pins on the 9-pin connector; or look at the pinout diagram by selecting the “Pinouts” tab, then
the “9-pin” tab in the stand-alone program.
Now you can click on OUT0 or OUT1 in the AUX tray to see the LED on the Demo Board to which it is
connected, light up.