1
2
4
A
Type
CUBE CO
2
Power
100W / 230V / 50Hz
Refrigerant
R134a 36g / 0,0515 t CO
2
eq
Service
www.quooker.com
Inlet pressure
Water
2 - 4 bar
CO
2
max. 4 bar
CO
2
IN
1 Connect the CUBE stop valve
Switch off the Quooker tank and pull the
plug from the power socket. Turn off the
mains water supply. Disconnect the tap’s
cold water supply and remove the old
hose screen. Place the fibre washer into
the pressure reducing valve. Connect the
valve to the cold water supply and tighten.
Place the first new hose screen into the
pressure reducing valve then connect the
CUBE stop valve onto it and tighten. Place
the second hose screen into the CUBE
stop valve, then connect the tap’s cold
water hose to the stop valve and tighten it.
2 Connect the white hose
Push one of the white hoses provided
into the CUBE stop valve (A). Ensure the
hose is fully inserted into the stop valve.
Tighten the coupling so that the red
marking is no longer visible.
3 Remove protective caps
Remove both protective caps from the
(IN) and (OUT) push fit connections by
pushing the grey ring down and pulling
them out.
4 Connect the CUBE
Push the white hose (A) into the water
inlet on the CUBE (IN). Push the second
white hose (B) into the water outlet on the
CUBE (OUT). Ensure the hoses are fully
inserted into the push fit connections and
carefully pull on them to ensure they are
secured firmly in place.
Water connection
• The hoses are connected using push-fit connections. No additional sealants are required.
Make sure that the hoses are not bent or pulled taut during installation.
• The maximum incoming water pressure allowed is 4 bar.
• The Q-shaped button on top of the tank is the on / off switch. Once the water is up to
temperature the light on the tank will fade in and out.
A
A
B
3
