1 Remove the boiling water hose
Remove the boiling water hose from the
top of the tank using a 10 mm and a 14 mm
open-ended spanner.
2 Install T-joint
Place a new small fibre washer onto the
tank connection then connect the T-joint
using the same spanners. Remove the old
fibre washer from the boiling hose and
replace it with a new one. Connect it to the
T-joint and tighten. Push the white hose
(B) into the T-joint push fit connection.
Check that the hose is installed correctly
by carefully pulling on it to ensure it is
secured firmly in place.
3 Connection to the Quooker tank
Remove the rubber blanking piece
covering the secondary port at the back
of the Quooker tank cover. Insert the black
jack plug connector firmly into the port,
until no more copper is visible.
4 Connection to the CUBE
Insert the blue jack plug connector (on the
other end of the cable) into the blue port
at the back of the CUBE cover.
1
3
2
4
B
B
10
14
Connect the CUBE to the Quooker tank
• Please note: Make sure that the hose between the Quooker tank and tap has cooled down
before removing it.
• There are two jack plug ports at the back of the Quooker tank cover which will be used to
connect the Quooker tap and the CUBE. One of the ports is covered by a plastic cap that must
first be removed.
• The CUBE and the tap are connected on top of the tank using a mini jack connector.
