Quinton ClubTrack, Руководство по обслуживанию

Страница: 36 / 148

•
Be sure treadmill area is free of liquid spills before removing
hood.
Burns
•
Allow pulleys, motor, and other treadmill parts to cool
sufficiently before touching them.
•
Unplug the treadmill immediately if signs of overheating
occur.
Mechanical
•
Be sure the treadmill power cord is unplugged before
working with chain, rack gear, belts, and pulleys.
•
Secure long hair, loose clothing, and jewelry before working
near the treadmill, particularly near walking surfaces and
rotating parts.
•
Before running the treadmill, check for worn parts which
could break loose during service or operation.
•
Keep fingers away from rotating parts.
•
To avoid eye contaminants, clean away dust and debris from
moving parts before servicing.
•
Beware of sharp edges when replacing worn parts.
•
Do not start the walk belt when someone is on the treadmill.
•
Improper lifting can cause back strain. It also can cause injury
to others if the treadmill is dropped. Lifting the treadmill
requires at least two people.
Tools
• Phillips and flat blade screwdrivers
• Hex socket wrenches: -in, -in, -in, -in, -in
• -inch nut driver
• Heyco
®
strain relief pliers for replacing hard-wired power cord
• -inch crowfoot open-end wrench for removing drive motor
• Torque wrench for rack wheel replacement, 46± 4ft-lbs
• Frequency counter
• Tachometer
• Wooden blocks (2" x 4" x 6" long)
• Belt tension calipers P/N 30113-001 (optional)
• Masking tape or heavy pencil
A
Although some procedures are used for several applications
(removing the hood, for example), each procedure is explained
only once. Reference procedures under their headings for
subsequent applications.
A
All references to front, rear, left, and right are given as though
you were facing the controller while walking on the deck.
5
32
9
16
7
16
1
2
5
16
11
32
1
2
Repair/Replacement and Calibration 4-2