Quinton ClubTrack, Руководство по обслуживанию

Страница: 89 / 148

• When this is completed, the LEDs light up individually,
starting from the top. The
Select LEDs light up first, followed
by the Units LEDs.
• After the LEDs are tested, all digits in all three displays
simultaneously count up from 0 to 9 (no decimal points are
illuminated during this count).
Test the Tri-color Display (ClubTrack Plus
®
only)
1. Press
Next Stage+Up+Down
until the test begins.
_
Vertical columns on the tri-color display light red, green,
and then yellow for one second each. The columns move
from left to right until all display LEDs have been tested.
_
Horizontal columns light red, green, then yellow for one
second each. The columns move from top to bottom until
all LEDs have been tested.
_
All LEDs go dark when the test is finished.
2. Press
Power
twice to exit Service mode.
Test the Heart Rate Monitoring (HR treadmills only)
Use a pulse simulator (P/N 34198-008) and a Polar watch receiver
(P/N 34198-009) to test the accuracy of the controller’s heart rate
function.
1. Turn on the pulse simulator. The LED on the front of the
simulator will blink in synch with the signal.
2. Place the Polar watch receiver next to the pulse simulator to
begin receiving. The watch will display the digital heart rate.
3. Check the rate displayed on the watch against the rate
displayed on the controller. If the controller differs by five
beats, replace the receiver (P/N 34295) and re-test. If the
problem remains, replace the controller assembly
(HR ClubTrack, p/n 34297, HR ClubTrack Plus p/n 35258).
D. Test the Grade Operation
1. Remove the hood (refer to Removing Treadmill Hood in
Chapter 4, Repair/Replacement and Calibration).
2. Ensure the controller displays 0.0% grade.
3. Measure the distance from the floor to the lower edge of the
sideòcal cover at the rear support and at the front grade wheel.
Both measurements should be the same ±
in. If they are
not, refer to Calibration Procedures in Chapter 4, Repair/
Replacement and Calibration.
4. Increase the grade to 15.0%
5. Measure the distance from the floor to the bottom front edge of
the head. Refer to the following table for the correct
measurement:
3
8
Field Functional Tests D-4