Quinton ClubTrack, Руководство по обслуживанию

Страница: 67 / 148

To open custom mode,
1. Turn the
Power
key off.
2. Press and hold the
Menu
key, then press
Power
.
3. Select Maintenance Information.
Limited Access Switch
If the limited access control is on, the treadmill will not operate
unless the magnetic key is on the Quinton logo on the controller.
Disabling the Limited Access Switch
1. Remove the magnetic key and press
Power
to turn off the
treadmill.
2. Simultaneously press and hold the
+
,
—
, and
Power
keys
until the 8s on the display go off, then release the keys.
The control remains inactive, allowing unrestricted access, until
you place the key over the logo again.
Calibration Procedures
Grade Potentiometer (Grade Pot)
Calibrate the grade pot whenever you replace the grade pot, either
rack gear, or the pinion shaft.
1. Disconnect power and remove the hood as previously described.
2. Loosen the setscrew that holds the grade pot gear to the grade
pot shaft.
3. Restore power to the treadmill. Maintain caution when
working near moving parts .
A
In order to enter open loop mode, grade must be positive.
4. Enter open-loop grade mode:
a. Press
Power
.
b. Simultaneously press
Stop
,
Faster
, and
Slower
on the
controller to place the treadmill in service mode. The
display will read
0.0 P000 0.0.
c. Simultaneously press
Faster
,
Up
,
and
Down
. The display
will read
0.0 P000 0.0.
d. Simultaneously press
Stop
,
Faster
, and
Slower
to exit
service mode. The display should read
0.0 P555 0.0
.
You
are now in open loop mode.
A
While in open loop mode, the treadmill takes approximately
two seconds to react to a command.
Repair/Replacement and Calibration 4-33