Quinton ClubTrack, Руководство по обслуживанию

Страница: 62 / 148

Controller Assembly
The controller assembly includes the keypanel, the PCBA, and the
enclosure that holds them to the treadmill:
• The ClubTrack and MedTrack CR60 and SR60 use the enhanced
display processor unit (EDPU).
• The ClubTrack Plus uses the motivational control unit (MCU).
• The HR ClubTrack uses the heart rate monitor (HRM).
• The HR ClubTrack Plus uses the heart rate controller (HRC).
You must configure the controller correctly after installing
(pg 4-30).
Removing the Enclosure
1. Turn the treadmill power off and disconnect the power cord
from the power source.
2. Remove optional siderails if present.
While performing Steps 2-7, hold the enclosure securely, so that it does
not fall while you are removing the screws and the handrail. Be careful
not to scratch the uprights.
3. Use a -inch Allen wrench to remove the six socket screws
from the rear cover of the enclosure.
4. Use a -inch Allen wrench to remove the two socket screws
near the handrail
5. Slide the cover down the uprights to expose the PCBA.
6. Disconnect the controller cable, located on the left side of the
PCBA.
7. Remove the hex nut that holds the ground wires to the
chassis, then remove the wire.
8. Cut the cable tie that holds the cable to the controller.
9. Use a -inch Allen wrench to remove the four socket-head
screws that attach the controller assembly to each upright.
10. Lift the entire controller assembly clear of the uprights.
11. Reassemble following Steps 2-9 in reverse order.
1
8
Socket screw on enclosure,
10-24 x 0.50L (10829-405)
Flat Washer (19409-003)
3
16
5
32
Interface Connector,
HR ClubTrack Plus
only
Repair/Replacement and Calibration 4-28