Chapter 4: Operations
Diagnostic and Maintenance Functions
58
Quantum LTO-5 HH SAS Model C User’s Guide
Caution:
For this test, insert only a scratch (blank) data cartridge or a
cartridge that may be overwritten. During the test, the
drive overwrites the data on the cartridge.
Note:
If you inserted an invalid tape cartridge (e.g. Gen2 or WORM
media), error code J or 7 appears in the SCD. If you inserted a
write-protected cartridge, or the media has read-only
compatibility (e.g., Gen3 media), error code P appears in the
SCD. In either case, the tape drive unloads the cartridge and
exits Maintenance Mode after the cartridge is removed.
1
Place the drive in Maintenance Mode. For instructions, see
2
Press the Unload Button once per second until H appears in the SCD.
(If you cycle past the desired code, press the Unload Button once
per second until the code reappears.)
3
Press and hold the Unload Button for three or more seconds, then
release it to select the function. The SCD changes to a flashing C.
4
Insert a scratch (blank) data cartridge. The SCD changes to a
flashing H. The tape drive runs the tests.
• If no error is detected, the diagnostic will loop and begin again.
To stop the loop, press the Unload Button for one second and
release. When the diagnostic ends, 0 temporarily appears in the
SCD, and the tape drive exits Maintenance Mode.
• If an error is detected, the Fault light flashes and the drive posts
an error code to the SCD. To determine the error, locate the
Appendix A, Error Codes and Messages
. To clear the
error either turn the power off and then on again, or reboot the
drive by pressing and holding the Unload Button for 10
seconds.
Function Code J: Fast
Read/Write Test
Approximate Run Time = 7 minutes per loop
Total Number of Loops = 10
Function Code J performs tests to ensure that the drive can read from
and write to tape.
Содержание LTO-5 HH SAS C
