Chapter 3: Installation
Connect the SAS Bus Cable
Quantum LTO-5 HH SAS Model C User’s Guide
25
Connect the SAS Bus Cable
The requirements for SAS bus connections are different than for the
SCSI bus. Each tape drive is required to have a dedicated bus to the
initiator, referred to as point-to-point connection. SAS architecture does
not support multiple tape drives connected to a single host adapter
port. The maximum SAS cable length that can be used to connect the
host adapter to the tape drive is 5.5 m.
To connect the cable:
1
Ensure the tape drive is powered OFF.
2
Since there are several types of SAS connectors, verify the SAS cable
has the correct connectors for the SAS host adapter and for the tape
drive.
3
The tape drive has two SAS ports and can be connected to two
servers, if desired. Refer to the appropriate figure that represents
your configuration for cabling information (see
or
on page 26) and then connect the SAS cable(s) to SAS
host adapter(s) and to the tape drive as shown.
Figure 5 Example of
connecting one SAS device
to the server
1 Tape drive
4 SAS host adapter card
2 SAS connector
5 Server
3 SAS cable
Содержание LTO-5 HH SAS C
