Warrior Extreme Blood and Fluid Warmer Instructions for Use
Preparing and Operating the System
QIF-IFU-00001 Rev. A6
Page 16 of 28
Remove the empty battery from the Warrior Extreme by
opening the two side latches and pulling out the battery.
Replace the empty battery with a fully charged battery
and close the side latches.
Pay attention to the correct battery insertion orientation:
the battery label should be alongside the
Base Unit
label.
If you insert the battery in the wrong orientation, the
battery will not dock with the
Base Unit
. If this happens,
remove the battery, turn it 180 degrees and reinsert into
the
Base Unit
.
Switch on the Base Unit. The LCD displays the
“Initializing…” message and a steady beep is sound.
Start flowing IV fluid / blood through the Compact
Disposable Unit The system will reach the set-point
temperature in a few seconds.
During this time the LCD displays:
Heating
Tout: outflow temp °C (inflow temperature °C); the
temperature is presented in Celsius degrees (°C).
For example: “Tout: 38 °C (8 °C)”.
Follow the fluid or blood administration instructions
provided by the manufacturer of the IV/blood
administration set and your facility protocols.
