Quadratec Quadratop 12020-2000, Руководство по установке

Страница: 17 / 20

17
STEP 3: OPERATION OF QUADRATOP 4-POINT HARDTOP HOIST SYSTEM
A. Unbolt hardtop from vehicle. Follow manufactures
instructions. Top will need to be free from vehicle to
properly adjust ropes and webbing straps.
B. Prior to placing tension to ropes Inspect all pigtail lag
bolts and pulleys. Align pigtail lag bolts in the
direction of the rope and pulley. Pulleys and rope
should not touch or bind on pigtail lag bolt. All ropes
and webbing straps should have equal tension to
insure level lifting. Check by slowly pulling the blue
hoisting rope. Tension can be equalized by adjusting
webbing straps at buckle and moving figure 8 knots
up or down.
DISABLE GARAGE DOOR OPENER WHEN INSTALLING, RAISING, OR LOWERING THE
HOISTER. DO NOT RAISE OR LOWER WITH ANYONE STANDING UNDER OBJECT. KEEP
AREA BELOW HOISTER CLEAR. IF THE LOAD FALLS IT CAN CAUSE AN ACCIDENT.
WHEN OPERATING SYSTEM, MAKE SURE AREA BELOW OBJECT IS CLEAR OF PERSONS.
IF OBJECT COMES DOWN TOO QUICKLY; THIS CAN CAUSE AN ACCIDENT.
C. Lifting Block and tackle operates by pulling down on blue/black lifting rope. With blue/black lifting rope pointed
down, the locking cleat will engage and hold lifting rope in place with each pull. Always inspect block and tackle
while lifting to insure locking cleat is operating properly.
D. Lift hardtop by pulling down in single short pulls. With hardtop raised slightly off vehicle check to see if hardtop is
lifting level. Further adjustment may be needed at this time. Do not lift until hartop is lifting level. With hardtop
eveled continue to lift into desired position.