QTech QSW-2800 series, Руководство по настройке

Страница: 374 / 415

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
360
51.3 MRPP Typical Scenario
MRPP typical configuration scenario
The above topology often occurs on using MRPP protocol. The multi switch constitutes a
single MRPP ring, all of the switches only are configured an MRPP ring 4000, thereby
constitutes a single MRPP ring.
In above configuration, SWITCH A configuration is primary node of MRPP ring 4000, and
configures E1/1 to primary port, E1/2 to secondary port. Other switches are secondary nodes
of MRPP ring, configures primary port and secondary port separately.
To avoid ring, it should temporarily disable one of the ports of primary node, when it enables
each MRPP ring in the whole MRPP ring; and after all of the nodes are configured, open the
port.
When disable MRPP ring, it needs to insure the MRPP ring doesn’t have ring.
SWITCH A configuration Task Sequence:
Switch(Config)#mrpp enable
Switch(Config)#mrpp ring 4000
Switch(mrpp-ring-4000)#control-vlan 4000
Switch(mrpp-ring-4000)#fail-timer 18
Switch(mrpp-ring-4000)#hello-timer 5
Switch(mrpp-ring-4000)#node-mode master
Switch(mrpp-ring-4000)#enable
Switch(mrpp-ring-4000)#exit
Switch(Config)#interface ethernet 1/1
Switch(config-If-Ethernet1/1)#mrpp ring 4000 primary-port
Switch(config-If-Ethernet1/1)#interface ethernet 1/2
Switch(config-If-Ethernet1/2)#mrpp ring 4000 secondary-port
Switch(config-If-Ethernet1/2)#exit
Switch(Config)#
SWITCH A SWITCH B
SWITCH C SWITCH D
Master
Node
MRPP Ring 4000
E1 E2
E1
E2 E1
E12
E1
1