QTech QSW-2800 series, Руководство по настройке

Страница: 22 / 415

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
8
configuration procedure should like the following:
Switch>enable
Switch#config
Switch(config)#username admin privilege 15 password 0 admin
Switch(config)#authentication line web login local
Notice: When configure the switch, the name of the switch is composed with English letters.
1.1.2.3 Manage the Switch via SNMP Network Management Software
The necessities required by SNMP network management software to manage switches:
IP addresses are configured on the switch;
The IP address of the client host and that of the VLAN interface on the switch it subordinates
to should be in the same segment;
If 2) is not met, the client should be able to reach an IP address of the switch through devices
like routers;
SNMP should be enabled.
The host with SNMP network management software should be able to ping the IP address of
the switch, so that, when running, SNMP network management software will be able to find it
and implement read/write operation on it. Details about how to manage switches via SNMP
network management software will not be covered in this manual, please refer to “Snmp
network management software user manual”.
1.2 CLI Interface
The switch provides thress management interface for users: CLI (Command Line Interface)
interface, Web interface, Snmp netword management software. We will introduce the CLI
interface and Web configuration interface in details, Web interface is familiar with CLI interface
function and will not be covered,
please refer to “Snmp network management software user
manual”.
CLI interface is familiar to most users. As aforementioned, out-of-band management and
Telnet login are all performed through CLI interface to manage the switch.
CLI Interface is supported by Shell program, which consists of a set of configuration
commands. Those commands are categorized according to their functions in switch
configuration and management. Each category represents a different configuration mode. The
Shell for the switch is described below:
Configuration Modes
Configuration Syntax
Shortcut keys
Help function