QRS QRS-101, Руководство по эксплуатации

Страница: 19 / 40

GB
After starting the therapy the display will show the following typical contents:
On the display’s left side the current therapy number and therapy description (plain text) will be shown,
alternately, on its right side you can see the remaining time until the end of therapy. The time of day, the
corresponding applicator jack, as well as the preselected therapy duration are not displayed during the
therapy.
THERAPY 3 06:21
!
NOTES
• In making a chip card the maximum number of therapies to be performed by the patient
will be prescribed. This credit of therapy units will be deduced by one after performing
each therapy. As soon as this credit has been exhausted the corresponding therapy may no
longer be selected from this chip card. Please contact your physician or therapist as soon as
possible.
• If a QRS
®
-101 or QRS
®
-101 P control unit, containing a chip card with automatical, time-
controlled start of therapy („autostart“ option), is taken out of the power supply and
reconnected later, the device will switch on, independently, display the text „AUTOMODE“
and switch off again. The same display appears if a chip card is inserted into a switched-off
control unit.
3 . 4 T I M E R M O D E ( O N LY Q R S
®
- 1 0 1 )
QRS
®
-101 contain 2 independent „timers“. These programmable timing circuits serve to automatically start a
therapy. Here you are free to choose the starting time as well as all therapy parameters (therapy program, intensity,
duration and applicator).
The timers have to be programmed and activated before their fi rst use. Afterwards the timers will start the selected
therapy every 24 hours, unless they have been deactivated explicitly.
Both of the QRS
®
-101 timers are equal and will be activated and programmed the identical
commands. The following example shows the commands for timer 1. Timer 2 is to be handled identically.
!
NOTES
• To perform a therapy in timer mode the device may be turned off but must be
connected to a live power supply (see chapter 2.2, Power Supply).
• At the fi rst use of the timers they are set as described in chapter 3.1.6, Restore
Basic Settings.
21