PVA Emergence PRO, Руководство по эксплуатации

Страница: 41 / 68

Emergence PRO ™ 3D Printer Manual
Revision C / December 2020
Page 41 of 68
Print
Printer Control Screen
The printer control screen is a touch screen controller consisting of four screens: Control,
Print, Console, and Setup. See Figure 12 on next page.
1 Stop Button Stops and reboots printer.
2 Bed Button Sets bed to active state or standby.
3 Hot End Button Sets hot end to active state or standby.
4 Current Temperature Displays current tool temperature.
5 Active Temperature Set point for active tool temperature.
6 Standby Temperature Set point for standby tool temperature.
7 Print Head Position Displays position of print head.
8 Axes Homing Buttons Homes the print head in all axes or in an individual axis.
•
Auto homing -- button on the far left
•
X-axis -- button in the middle left
•
Y-axis -- button in the middle right
•
Z-axis -- button on the far right
9 Bed Probe Probes bed and creates bed level profile.
10 File Selection Displays available prints.
11 Move Selection Allows movement of print head
•
X-axis -- negative moves left, positive moves right
•
Y-axis -- negative moves towards front of the
machine, positive moves towards rear of the machine
•
Z-axis -- negative moves up, positive moves down
12 Extrusion Selection Allows for extrusion of filament when hot end is at
temperature.
13 Macro Selection Allows for selection of macros. Four macros are found on
the right side of the Control Screen: Check Bed Level,
Quick Level, Replace Filament, and Reset Heaters.
Additional macros can be accessed by selecting Macro
button.