6
Models PVP1100, PVP1100EVR, PVP2000, PVP2000EVR, PVP2500, PVP2800, PVP3000, PVP3500
Locate the wall studs in the desired location and align the mounting bracket over a single
1.
stud. Mark the mounting holes ensuring holes C, D, E and F are directly over the single
stud (see Figure 3-2).
VERIFY THE BRACKET IS LEVEL. Ensure points C through F are aligned with the
2.
wall studs. Drill 1/8” pilot holes for the screws.
Use heavy-duty 1/4” x 2” coarse thread lag screws to secure points C through F to
the wall.
Use an 1/8” screw to secure points A and B (See Figure 3-2).
A
E
D
C
B
F
Mounting Hole
Figure 3-2 Mounting Bracket
Carefully hang the inverter on the upper part of the bracket. The hooks located at the rear
3.
of the inverter should hang over the bracket.
Verify inverter is level.
4.
Remove the front cover of the inverter by unscrewing the four cover screws located
5.
around the front perimeter of the inverter.
Locate the inverter mounting hole below the power board (see Figure 3-3). Insert the
6.
mounting screw through the inverter and tighten securely.
Figure 3-3 Inside Screw (below the power board)
Содержание 1100
Страница 37: ...30 Notes ...
Страница 41: ...34 ...
Страница 42: ...150 SW Scalehouse Loop U Bend OR 97702 U P 541 312 3832 U www pvpowered com ...
